Ford Mustang Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
I WORK AT A METAL FABRICATION SHOP AND NEED MEASUREMENTS OF INNER ROCKERS ON A 65 CONVERTIBLE MUSTANG. i HAVE LOOK EVERYWHER I COULD THINK OF AND NOONE HAS EXACT DEMENSIONS.
 

·
Registered
Joined
·
237 Posts
I just replaced my inner rockers - little hard to measure though since now that floor is in. You do know you can by inner rockers right?
 

·
Registered
Joined
·
62 Posts
Discussion Starter #3
Yes, It's cheaper for me to build them myself all I will have is 30 minutes labor in them since I have the material and machinery. I also want to make mine out of a heavier gauge metal that is why I need original measurements to allow for bend allowance. I have already made and installed the lower fender patches on both fenders and the spot at the bottom front of both doors and they turned out well. All together i figured I have saved a couple hundred dollars and want to continue doing it especially since this is my final build
 
1 - 3 of 3 Posts
Top