Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
197 Posts
Discussion Starter #1
Just got word that the inside trunk lid mat (and extenders) I ordered will be arriving this week! Very excited. Looking for any insider tips on the installation. I have seen the video on YouTube and have the general idea. Just wanted to see if anyone learned any good info from their installations to pass along, thanks!
 

·
Registered
Joined
·
2,820 Posts
The only tip I will pass on is when you drill the holes, place a catch cover underneath the bottom lip of the trunk lid (in its up position) to catch all the little metal shavings. I placed a cover on the trunk mat, but forgot about some shavings getting into the well between the lower part of the windshield and rim of the trunk. Only takes a day or two and you'll see little rust snakes... They cleaned out ok and a little touch up paint and all was fine. The rest of Phil's (GDM) instructions are right on.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top