Ford Mustang Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter #1
From reading other threads about short throw shifters, the MGW seems to be the shifter of choice. How hard is it to install? Do you have to get under the car? Should I just let a professional install it. And advice would be appreciated.
 

·
Registered
Joined
·
1,452 Posts
If you are semi-skilled mechanically, you can do it by following the video CD. You also really must jack at least the front end with jack stands under it. That's how I did mine a little over a year ago and I love the thing. It's something you can enjoy each time you drive the car, whether or not you get on the gas.

I set mine at 7 turns out and haven't wanted to change it.

Frank
 

·
Registered
Joined
·
52 Posts
I just installed a Hurst Billet Comp Plus is my '05. It was the easiest thing to do. There are only 4 bolts to remove to take out the stock shifter. The center console is way too easy to take out. Just a couple of things I ran into that were not in the instructions. My OEM shifter had a safety clip on it that was a pain to get off. Some wiggling and pulling made short work of it. If you don't have a ratcheting box end 10mm for the front bolt, get one. It will make life very easy. Also when removing the front 10mm bolt use a long box end wrench to get some leverage, its a tight space. The last thing I did was install the new shifter from the bottom. There was no way of sliding the new shifter in from the top. It was tight, but I was able to slide the shifter between the drive shaft and the transmission tunnel. You may have to rotate the drive shaft if the balance weight is in the way. I did have a lift to work under, but this can be done in the drive way with jack stands and a creeper. Don't pay someone to do this, its way to easy. Good luck.
 

·
Registered
Joined
·
205 Posts
I was able to install my Hurst shifter in about 2 hours taking my time. Check out my comments at american muscles site under the FRPP shifter.
 

·
Registered
Joined
·
465 Posts
I love my MGW shifter. Like the others, it's an easy install. It came with complete instructions and photos. It took me 3 hours, but I'm a slow worker. I will never miss third gear again, and never miss fourth shifting down from fifth.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top