[ATX5.Slow]

Ok so i just got some long tube headers and wanted to see if anyone had some advice in installing them the fastest im doing them this weekend and i have everything ready just wanted a few pointers thanks :bigthumbsup

 

[fastford727]

You have a stock k member in the car?

 

[Smurf stang]

Nothing about doing them but it dpends on the brand of header also..i have Mac's long tubes and the easiest way is to jack the car up as high as possible,unbolt my motor mounts,jack the engine up 2-3", remove the steering shaft, and feed the header in from underneath the car. Going by the bottom is much easier and also to have a helping hand works best.

 

[fastford727]

Smurf said it all:bigthumbsup

 

[BT885.0]

+1 to Smurf. Thats by far the easiest. The only pointer not mentioned that I can give is bring A LOT of patience. They are a PITA! I found it easier to remove the starter also. Thats a personal thing though, it maybe easier for you to keep it on.

 

[ATX5.Slow]

Cool thanks yall i will keep all this in mind this weekend when i do the exhaust :cooldude: