Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hello:

When I pulled my 302 and tranny out of my 90 GT I just hooked the engine lift to some head bolts to pull her. Now that I have my motor fully reassembled with new heads and all I am looking to put it back in with the tranny attached. What bolts are my best bet to attach the engile lift to to hoist it back into the bay?

Thanks!
 

·
Registered
Joined
·
547 Posts
im not one to feel safe lifting a motor and tranny with the intake manifold i know people do it all the time, but with my luck it would do damage, but i put my fully assembled 302 and t5 tranny in i bolted one bolt to the back of the passenger side head and the other to the hole where the stud for the power steering goes on the drivers side and i just angled the motor right so it slid right in
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top