Ford Mustang Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
2,096 Posts
Discussion Starter · #1 ·
Hey guys i finally had the time to go pick up my tb/plenum that was delivered but i wasnt home.

I am going to install it on thursday, only day i am off in afternoon

What do i need to have with me... i have all tools... do i need any rtv or anything like that. also i have heard that for my car since its a 02 and any pre 03s need a larger host for the plenum PCV, can some one explain?

i also have heard about checking volatage on the TPS sensor needing to measure like .97-.99 volts or something.?

anything i am missing ?
 

·
Registered
Joined
·
5,907 Posts
You'll need a nutdriver or socket/ratchet ( don't remember the size ), no RTV as long as the gasket comes off cleanly, CLEAN cloths to put over intake manifold while the TB and Plenum are off the car and that's about it. A DC Voltmeter is needed also if you're going to verify the TPS voltage. I don't remeber which wires you need to poke into to get that.
 

·
Registered
Joined
·
2,096 Posts
Discussion Starter · #3 ·
i can check voltage with predator just need to toy with it to figure it out. what should it be
 

·
Registered
Joined
·
5,907 Posts
.97-.99 VDC at idle.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top