Ford Mustang Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
118 Posts
Discussion Starter #1
Howdy, i have edelbrock e street heads and a cobra intake ready to go on my car, which is a 1990 gt. And i know that the runners on the intake are a little bit smaller that the runners on the head. now, my question is, should i use a gasket that matches the head, or the gasket that matches the intake??? Any input, as always, is appreciated. thx
 

·
Registered
Joined
·
511 Posts
you should get a gasket to match the heads and port the intake:D. seriously though i would get a gasket that matches or is slightly larger then the runners on the heads.
 

·
Registered
Joined
·
394 Posts
Or you can get the Edelbrock Performer and Performer RPM intake manifolds. They are matched in size and operating range with you heads. Or what JMertins said about porting your lower intake.​
 
1 - 3 of 3 Posts
Top