Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
1,241 Posts
Discussion Starter #1
does anyone know where i can get a good intake manifold for a EFI 351W. (for under 500$) i have the proffessional products and it sucks. they did a crappy job when machining it and some of the lower intake bolts wont even reach the heads so i can tighten them down. even the upper intake has 2 bolts that are a little bit off and when i try to torque them to spec, they just spin loose.
 

·
Registered
Joined
·
165 Posts
check on ebay, i found my ported gt40 351 lower (already had the upper) for 300.
 

·
Registered
Joined
·
46,010 Posts

·
Registered
Joined
·
1,241 Posts
Discussion Starter #4
i saw that one at summit, it is a little pricey but i could buy the lower manifold from summit and look on ebay for the upper half because its the same for the 302 as 351. i just want everyone to know that proffessional products manifolds are garbage and dont waste your time or money, thats the only thing ive put on the mustang that was "cheap" and i regret it.
 

·
Registered
Joined
·
46,010 Posts
Good idea on buying just the lower because the uppers are the same. Bummer the Professional Products intake bombed on you.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top