Is it that difficult to stripe a car.

I did my own in my garage. Took me at least 7 hours. Not hard but you do have to follow the directions.

It's not hard. You'll mark everything with grease pencil and masking tape. Once the stripes go on, you have a good 30 seconds to get them positioned before the adhesive starts to take hold.

GoStang said:

Do you wet soap the under side so the vinyl can slide and at what point do you press the vinyl to the car?

Click to expand...

You make a mixture of original dawn dishwashing liquid (it has to be dawn) and put it in a spray bottle. You spray the stripe and position it. At that point you use a very soft squeegee to push the solution and any air bubbles out from under the stripe. The key is to follow directions and not to rush!

Here's a good set of instructions

If you rush it's easy to end up with air bubbles. Then you're stuck popping them with a pin.