Ford Mustang Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1
I got my headers installed but, the passenger side bangs on the passenger side pretty bad. Has anyone else had this problem, I searched but nada. I'm thinking of looking for different motor mounts. Anyone else have any better ideas?
 

·
Registered
Joined
·
2,396 Posts
Unless you put the headers on the intake side of the head, bent the header tubes on install you should not have any issues...
To have issues Kooks sold you a bad set or you installed them incorrect... Kooks makes one of the best fit headers for the 2011 mustang for fit

You don't need new motor mounts...

Check the pipe attached on the outlet side, catted or not... The headers fit fine...
I know the passenger side of the swap is a Major ***** to do...
LOL hell your motor mount may not be tight to frame or the block...
Make sure all bolts are tight I mean all bolts... any thing you touched to do the swap, check everything...
And check that you do have some clearance for the header and exhaust pipe...
The X or H, what ever you have to high, " to close to the bottom of the car" the tail pipe going over the axel will hit the body in the rear axel area...
 
1 - 4 of 4 Posts
Top