Ford Mustang Forum banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have an 1984 LX Mustang with a 302 engine, I would like to swap it for a 351W out of my 1984 Bronco. The 5.8 engine is carburated and complete, ready to be remove. I need to know besides hood clearence and going to a electrice fan for my radiator what else do I need. Can I use the stock pullys, oil pan, and what kind of clutch should I use for my T5? Is there a complete kit that can drop this engine in place, without much headache? Any advice would be greatly appreciated.
 

·
Registered
Joined
·
5,023 Posts
Welcome to the site, glad you joined us:)
 

·
Registered
Joined
·
25,075 Posts
:wavey Enjoy the site!! :myhappydance: :happydancer:​
 

·
Registered
Joined
·
6,124 Posts
Welcome to the site. We did my friends 5.8 into his 89 and used all of the parts and his T5. Got rid of the factory headers and went with a set of long tube.
 

·
Registered
Joined
·
1,241 Posts
set of 351 swap long tubes, 351 swap oil pan.

you can use all your factory pulleys and accessories.
 

·
Banned
Joined
·
7,170 Posts
i have seen some kits out there, but ttop is right the only thing special is the headers and pan. :bigthumbsup sounds like a good swap!
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top