[Old Chuck]

While the car was on ramps doing an oil change and skip shift delete, I noticed a missing nut. The nut in question is in the harness that goes to the main transmission plug and the skip shift plug on passenger side. If you follow the lead forward from the tramission plug on lower transmission housing it goes over a member and mine has a retainer with a bolt but no nut. I believe the nut should hold the bolt and wire in place. There is enough tension that the wire does not hang down but there is what looks like a 10x1.25 bolt through the retainer but no nut on it. It is supported by a cross member but I don't think Ford would have put a bolt in without a nut. Can anyone identify what the exact size of the bolt IF the nut can not be identified. I went by my dealer and they did not have a diagram of that part so I could not tell what size the nut is. I figured that somewhere there must be a diagram of that part of the wiring.

 

[slagburn]

A picture would help a lot.

 

[Old Chuck]

Will post a pic next time I get her on the ramps. It is 12-15" from the lower major transmission sensor plug on passenger side toward the engine. The wire goes over the frame member and has a holding bracket with a good sized black bolt and mine is missing the nut. Looking for a diagram of the wiring that might show fasteners as well. Will post again with a pic unless someone has access to a diagram that will help me out..