LOW END POWER from 2.3 efi

862 Views 3 Replies 3 Participants Last post by 05horse, Jul 13, 2009

wht93lx

Discussion Starter · Jul 13, 2009

I have a 93 2.3 liter 4 cyl efi with low end torque when you brake torque it will not go over 2,000 rpm?? and i can't find a cold air intake for it i have found a performance chip for it but not put it in yet i NEED MORE POWER from the 2.3 can u help?:shiny:

Save

Status: Not open for further replies.

1 - 4 of 4 Posts

05horse

· #2 · Jul 13, 2009

theres some form of CAI somewhere or RAI

the stock torque converter is prolly keeping you at 2K

ride it long and keep doing it itl heat up and wear down.

what kinda chip did u get?

hopefully not the +80 HP and 36 MPG chip.

See less See more

Save

Amscray88kr

· #3 · Jul 13, 2009

get a free flowing exhaust. faster you can get those gases out the better. cai is a huge improvement. take out the air silencer and itll help alot.

other than that..i dunno t-5 swap lol a4ld is a dog :so

my gf and I were laughing about it earlier. foot all on the gas waiting for the power(POWER:hihi:...lol) to come on and it didnt lol.

See less See more

Save

05horse

· #4 · Jul 13, 2009

Amscray88kr said:
get a free flowing exhaust. faster you can get those gases out the better. cai is a huge improvement. take out the air silencer and itll help alot.

other than that..i dunno t-5 swap lol a4ld is a dog :so

my gf and I were laughing about it earlier. foot all on the gas waiting for the power(POWER:hihi:...lol) to come on and it didnt lol.

Top Contributors this Month