Ford Mustang Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
i am in the process of bolting on a cobra m112 o my 97 mustang but i have to first do a split port swap and then buy the adapter ect ect. i have a pully on my eaton that's like 2.8 pushing 14 psi which would wreck my engine. i was wondering if there was a place that sold stock eaton pullies or something close to what my engine can support. also i have seen alot of eatons that have one big bolt in the center of the pully BUT i have 5 or 6 hex bolts??? also i need a eaton vaccum hose diagram, any help is always appreciated....:frustrated:



p.s a stock eaton pully is 3.1 i was looking for maybe 2.9 or 2.8??
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top