Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
I just installed some full length mac headers on my 67 which I was told would work with my T5 swap and clutch cable conversion. Well after hours of struggling to get them in and bolted down, I went to install the last pipe which comes unattached for some reason, I realized that it fits exactly in front of where my clutch cable goes through the bell housing. Well this is frustrating to say the least. Does anyone know of a full length header that will work for my application
Thanks
 

Attachments

·
Registered
Joined
·
360 Posts
I think I would be having a conversation with whoever told you they would fit. You might check with Wndsor-Fox in CA or ?, sorry I'm kinda at a loss.
 

·
Registered
Joined
·
682 Posts
Windsor-Fox is more or less out-of-business, even though they do not acknowledge it, and they will still take orders on occasion (or did), and never deliver, now that they've "shut down". DO NOT do business with them! I've seen reports of Hookers working, IIRC.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top