Ford Mustang Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
I just installed some full length mac headers on my 67 which I was told would work with my T5 swap and clutch cable conversion. Well after hours of struggling to get them in and bolted down, I went to install the last pipe which comes unattached for some reason, I realized that it fits exactly in front of where my clutch cable goes through the bell housing. Well this is frustrating to say the least. Does anyone know of a full length header that will work for my application
Thanks
 

Attachments

1 - 1 of 1 Posts
Status
Not open for further replies.
Top