Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
hey how's it goin? anyone know a ball park figure on how much it would cost a machine shop to mill a 306 short block so a 347 kit could fit. i know its not much to mill i could do it but i have more trust in a machine shop doing it. i live in central NJ so if any one knows about how much and if there are any good machine shops around fill me in. thanks
 

·
Registered
Joined
·
1 Posts
It's usually about $85 to clearance a block for a stroker assembly. I have a performance automotive machine shop in Plymouth Meeting, PA. If it's not too far and you're interested, give us a call at the shop (610-275-1908). You could also check out our website: http://www.budzmotorsports.com

Hope this helps.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top