Ford Mustang Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
1,520 Posts
Discussion Starter · #1 ·
Hey All,

Quick question...I know that the MAP sensor works with speed density and the BP sensor works with MAF. When I converted to MAF, I disconnected the MAP(can I take the MAP unit out if I'd like?), but didnt put a BP sensor in for the mass air....should I have put a BP sensor in?? Tx.
 

·
Registered
Joined
·
46,010 Posts
When you converted, you probably had it in the instructions to unplug the MAP and leave it that way. That actually converts it over to a BP and it's fine as is.
 

·
Registered
Joined
·
941 Posts
ya just leave the vac line off the map and your good
 

·
Registered
Joined
·
1,520 Posts
Discussion Starter · #4 ·
Thanx for the responses.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top