[Paul in LKY]

Okay I have the motorsport mass kit conversion kit. Got it dirt cheap. But I need the pigtail that goes from the ECM to the mass air. Any ideas or can I just make one or what? If I can order it I will, but I can't find it anywhere. The ECM has the plug coming out of it kinna looks like a o2 plug so you don't have to slpice into the wires, but he didn't have the plug from the ECM to the mass air. HELP!!

 

[ALMOST STK]

You might try looking here.

RJM Injection Tech — Pigtails & Connectors

 

[Paul in LKY]

Thanks, but does anyone know where I can get the pigtail that runs from the adapter off the old ford motorsport kit to that mass air on the fender wall? Kit # E8ZM-12A582-B32. Thanks guys.

 

[johnnymg]

I have the same dilema, I bought the adapter piece in a deal with a c3w I have the MAF plug with wires for a conversion, I found that a O2 sensor plug will fit by cutting off one of the lugs, I figured the four pins out on the Motorsport plug with a VOM/ My question is does anyone have the instruction for the Motorsport unit. What else do I need to do to complete the conversion? Thanks for any help

John

 

[ny88vertible]

I forget who sells it, but it is available for i think like 80.00 if your desperate. I found everything on craigslist when i did mine. Did you try junkyards? Conversion is not bad, i got schematics off of stangnet and it was right on. Had it done in an afternoon. Good luck.

 

[ALMOST STK]

I have the same dilema, I bought the adapter piece in a deal with a c3w I have the MAF plug with wires for a conversion, I found that a O2 sensor plug will fit by cutting off one of the lugs, I figured the four pins out on the Motorsport plug with a VOM/ My question is does anyone have the instruction for the Motorsport unit. What else do I need to do to complete the conversion? Thanks for any help

John

This is the instruction sheet you're looking for.

http://runne-rite.com/MUSTANGPERFORMANCEKITINSTRUCTIONMANUAL.pdf

 

[johnnymg]

Thank You for the instruction sheet, now I just have to finish making the maf harness, was going to try to pull the pins fron the O2 plug, but I think I will just solder and shrink wrap the connections to the O2 plug wires.

thanks again

John