Ford Mustang Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
I just bought a mass air kit used and the guy doesn't have the instructions for the installation.. It is a Ford kit # M-9000-A51.. does anyone have or know of anyone that would have a set of instruction that I can get?.. Any help would be appreciated.. going racing in a week and a half and want to do the conversion before I go.. Thanks
 

·
Registered
Joined
·
103 Posts
I didn't use a Ford kit, but did the conversion.

Although the directions won't be exactly applicable,
you should be able to figure out what you need to know.
The wires that need to be added, and the pin #'s on the
computer, should be the same.

Send me your email

[email protected]

I've got them written up.

Or you could probly do a Google search and
come up with the articles, too.
 

·
Registered
Joined
·
33 Posts
Discussion Starter · #3 ·
macx said:
I didn't use a Ford kit, but did the conversion.

Although the directions won't be exactly applicable,
you should be able to figure out what you need to know.
The wires that need to be added, and the pin #'s on the
computer, should be the same.

Send me your email

[email protected]

I've got them written up.

Or you could probly do a Google search and
come up with the articles, too.
The kit comes with a adapter cable with a ECU plug that get sandwiched in
between the ECU and the car harness.. no plugs to add .. on the kit you used did you have to run a wire to the fuel pump relay? and did you have to unplug the vacuum lline to your MAP sensor?
 

·
Registered
Joined
·
103 Posts
That plug would definitely make things easier!

Otherwise, yes to both questions.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top