Ford Mustang Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

· Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
hi. i need some help quickly if anyone can. i own a 1995 mustang with a 3.8 v6 and is 323 cubic inches i have a very big problem i cant figure out. if any one can help me id like to hear and resonses
the car curently has the following symptoms:
mass over heating
hoses hot consitanly
too much pressure built up
coolant leak looks like from resivior but its not
might be thermostat, but checked and airs getting in
new mass flow sensor installed
new air filter
water pumps good, internal wheels in good condition
radiatior might be cracked but have checked and ran a hose through it and no aparent leaks anywhere
fan cuts in when car is almost about to cut off and cools untill it sits at 1/4 guage
oil pressure gauge reads over 3/4ths when car is ran
after about 15-20 minutes car cuts off from over heating.

the only other opton i can come up with is a possible manifold gasket but im not sure any one have any other opinions
 

· Registered
Joined
·
1,325 Posts
air is getting into the thermostat?

3.8 = 231 :p

Could be a blown head gasket, or some obstruction? Is there any whitish looking smoke coming out of the tailpipe? Is there coolant leaking onto the ground?

Oil pressure sounds fine.
 

· Registered
Joined
·
6,151 Posts
its 232 cubic inches.. but anyway.. 95s are known for head gasket issues so you probably have blown a head gasket.. have a compression test done for all of your cylinders.. someone else should chime in with their expert advice.. im no expert just saying what ive seen in the past
 

· Registered
Joined
·
19 Posts
its def a head gasket the overheating is coming from no coolent and it leaks into the cylinders also stop driving it because once it gets into the block its all over because it tears up the main bearings
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top