Ford Mustang Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter #1
Hi I want to have a custom stripe made, that takes the hood stripe of the 2013 boss 302, and extends it from bumper to bumper. Like a Supersnake stripe, except it would have 7 separate stripes like the boss 302.

problem is I cant find the measurements of the 302 stripe, could someone who is lucky enough to have a boss please measure the width of the stripe and tell me.

photos examples.
Screen Shot 2013-03-19 at 4.53.53 AM.png

Screen Shot 2013-03-19 at 4.53.29 AM.png

Screen Shot 2013-03-19 at 4.54.17 AM.png
extended like i want
530617_10151260522603940_912652946_n-1.jpeg

Thanks.
 

·
Registered
Joined
·
737 Posts
About 16 3/8" wide.

Also, I think Ford makes a stripe like that, just not sure if it goes over the roof.
 

·
Registered
Joined
·
64 Posts
Discussion Starter #3
sorry, to be clear I need the width of each stripe. And the distance between them so I can tell my stripe guy.
 

·
Registered
Joined
·
737 Posts
sorry, to be clear I need the width of each stripe. And the distance between them so I can tell my stripe guy.
The best I can do.

image.jpg

Since its a custom job does it have to be exact?
 

·
Registered
Joined
·
64 Posts
Discussion Starter #5
thanks that helps allot. I had been thinking the middle stripe was 12 inches instead of 10, and I hadn't realized the inside and outside pinstripes where different. Heck this is the first photo I've seen that actually showed the stripes off, so even without the tape measure its a big help.

Thank you.
 
1 - 5 of 5 Posts
Top