msd problems !!!

677 Views 4 Replies 3 Participants Last post by riko645, Jun 10, 2009

riko645

Discussion Starter · Jun 9, 2009

i've been having some strange problems with my car , i'm in low throttle it runs fine, when i step on it , it's starts backfiring and poping really bad and car doesn't seem to run as it did, i umplugged the msd box and it's not doing it so bad now it's barely poping and it feels like the car is running on 6 or 8 cilinders, what else can i check, timing i good, and plugs are new, wires aren't that good but i don't think thats the problem , ehat do u guys think?? thanks

Save

Status: Not open for further replies.

1 - 5 of 5 Posts

superstock

· #2 · Jun 9, 2009

what about the chip in the msd box. Like the rev limiter are you sure you dont have one set really low in?? I Know one time my dad played a joke on me when i took our 63 galaxie for a drive its pushing 475 hp and 512 ft lbs of torque and its fun to step on that gas pedal and when i did it acted the same way. Dont know if this help.

Save

· #3 · Jun 9, 2009

could be something in the distributor.....

also check all your vacuum lines & plug wires.....

bad plug wires will cause the problem you are describing.....

Save

EagleAutosports

· #4 · Jun 9, 2009

It's most likely distributor related. Check the output coming from the distributor.

Save

riko645

Discussion Starter · #5 · Jun 10, 2009

i'll check the wires and vacum lines, i kind off feels like a injector is taking a krap or something cause somethimes when i shut my car off it won't start back up unless i let it sit for a while or i pump the **** out of the pedal like a carbed car, somebody told me a injector might be sticking open or something like that , and by the way the msd box has no chip it's a 6a , and how could i check the output on the distribuitor:headscratch: thanks for the advice

Save

1 - 5 of 5 Posts

Status: Not open for further replies.

Top Contributors this Month