[HuntingKy]

Well, due to some 'puter problems etc. I haven't been on here much for awhile but I finally made a little progress on my build. So far I have installed:
inner and outer framerail patches on passenger side
battery apron
radiator support
front torque boxes
floor pans
floor pan extensions which I then removed
full firewall after removing the extensions
dash/radio opening patch
upper and lower cowl assembly
cowl ends

Starting on rear end soon and hope to have up on rotisserie soon

 

[senor_blue_302]

That looks awesome i need to learn how to weld

 

[sp66stang]

nice looking keep up the good work

 

[mustangdemon01]

Nice work! Keep it going!

 

[MurdockGT]

nice, saem boat, just didnt do the full firewall as you did. on to trunk area till i get fenders!!

 

[HuntingKy]

WOW! Realized that I really need to update this thread. Since last time, I have installed new trunk floors, new quarters, new tail light panels, roll bar brackets, Lizard Skin, Griggs GR350 front end, Raptor coating... time for some new pics. Here are a few pics of front fender repair. Had to patch both. I had considered using new but decided to save the old ones. A little more grinding and a thin layer of filler and I should be good to go.

 

[HuntingKy]

New trunk floors, modified them slightly to open up the wheel wells for more tire clearance.

 

[HuntingKy]

Along the way I had to sandblast everything.

 

[HuntingKy]

Installed subframe connectors. Even LOOKS stronger!