Ford Mustang Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
132 Posts
Discussion Starter · #1 ·
i have, crane cam (specs are like F 303 cam) rockers, not sure of ratios, valve springs, underdrive pulleys, mac shortty headers, offroad h pipe, flowmasters with dumps (and right side header gasket leak pretty bad, trhowing codes saying running lean) i also have k&n filter, advanced timing to 15*, made a custom ram air threw bumper for k&n, 245/50/16's in the rear, adjustable FPR, msd blaster coil, king cobra clutch, aluminum driveshaft, flex fan, punched out thermo, stock gears :(, and theres probly little stuff i left out, and i beat out a k20a integra twice, mx3 with klze swap, civic hatch with spray idk what shot, 350 friebird 91ish, 89' turbo civic, 2003 msutang gt from a roll back one, 2002 mustang gt from a dig,2006 wrx non sti and it was a realy close race. and i recently put in a 50 shot wet kit just for a little added punch and i raced an subie STI and he got be by about 1 lenth at about 100mph *from a dig*. i olny went 50 shot becusae i have oil blow by at high rpm, and idk if i have a cracked ring :headscratch:
 

·
Registered
Joined
·
5,023 Posts
Nice kills:bigthumbsup Watch out for those STi's, they are strong runners.
 

·
Registered
Joined
·
158 Posts
Race the STi from a roll, you will kill him. anything above about 80 or so they dont pull as hard as a stang. I killed one at a 40 MPH roll with my mostly stock 88 5.0.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top