Ford Mustang Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
359 Posts
Discussion Starter #1
ok so i recently got a v1 s-trim and the pulley it has now will make too much boost for my 93 pistons

so can you guys pick a pulley for me that will make 10psi on a vortech v1 s-trim with a original crank pully and a POWERPIPE thru gt40p heads ,cobra intake, tfs1 cam, and a free flowing exhaust i think my 5.0 has got about 285-290 to the wheels right now so 10psi it should be right under 400rwhp.


thanks for your time , Dean
 

·
Registered
Joined
·
369 Posts
You can go down to a 3.33 and still use the 6-rib setup. I do think that will turn that frown upside down :)
 

·
Registered
Joined
·
13,166 Posts
You need a 3.33 with the power pipe to be close to 10#. Your setup with 10# is only going to be around 350, unless you run e85 or meth.
 

·
Registered
Joined
·
359 Posts
Discussion Starter #4
my s-trim is a 8 rib i think


dang only 350
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top