Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
Ok i have a 89 gt with a 6 psi powerdyne supercharger on it. My lower intake gasket is leaking so i am going to change it but i have a performer rpm manifold in the garge. The motor is stock can i run that intake with BBk 75mm TB and EGR plate 30lb injectors 80 mm mas air and take my boost up to 9 psi. Going to upgrade the rails and have a edelbrock fuel regulator at the same time. I also have a MSD 6BTM and a crane interceptor II programmer. Does any one know if those items will work on stock motor. Or if the Interceptor will change the fuel curve enough to use 30 lb injectors on a stock motor??
 

·
Registered
Joined
·
4,806 Posts
That all sounds good to make. Just make sure the MAF is calibrated for those injectors.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top