Ford Mustang Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
162 Posts
Discussion Starter · #1 ·
I just installed my Snow Performance water/meth kit and I think I have everything done and its right and should be ready for tuning. BUT first I need a 12 volt ignition wire. I want it to only have power when the key is on. I would LOVE for it to be under the hood so I dont have to run it back instide the car but if I have to thats fine too. Plus I want it to be as easy of a place as possible. I dont want to be tear up into the dash or disassembling a bunch of crap just to get to the wires I need. But I really need to get it hooked up so I can go get the car tuned in for it, so a response asap will be greatly appreciated. TIA
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top