Ford Mustang Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter #1
I have a 1990 2.3 and I just took the sway bar out and painted it. It still has the original swaybar bushings in it so I would feel stupid to bolt up cracked pieces of rubber. Where can I find stiff polyurethane bushings for this car? And has anyone else done this. If so did it help much?
 

·
Registered
Joined
·
711 Posts
I have a 1990 2.3 and I just took the sway bar out and painted it. It still has the original swaybar bushings in it so I would feel stupid to bolt up cracked pieces of rubber. Where can I find stiff polyurethane bushings for this car? And has anyone else done this. If so did it help much?

Don't order and wait. Go to Pep boys or Advanced auto. They have them on the shelves. I seen them there. Guaranteed. I'm getting them from there when I get the 5.0 GT front sway bar. They are $20 a piece for both parts. To hold up the bar and on the ends with the rods. They even have the tranny mount in poly urethane. :bigthumbsup
 

·
Registered
Joined
·
711 Posts

·
Registered
Joined
·
711 Posts
I think the ones to hold it to the frame are 1 1/4" so I think they fit the 5.0 but the ones on the bars will fit. Go to the junk yard and get a 5.0 sway bar like I am.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top