Ford Mustang Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
91 Posts
Discussion Starter · #1 ·
Hey guys i was taking my car to a detail shop this morning and i noticed when i was sitting at a light with it in neutral and the clutch fully out there was a squeak/chirp noise. But when i push the clutch in just barely maybe 1/2 inch the noise goes completely away. Im really itching to get it back and check out more about the sound...

Any advice would be greatly appreciated

2004 Torch Red Cobra
9,000 Miles
2.8 Upper Pully
Idler Pully
Afco Pro Heat Exchanger
Upr Cai
Upr Offroad X-Pipe
Flowmaster Thunder Catback
Steeda Tri-ax shifter
Diablosport Predator
Custom tune at Mustang Motorsports
 

·
Registered
Joined
·
91 Posts
Discussion Starter · #3 ·
Whats it take to replace a throw out bearing and price wise? and will it hurt if i drive it with the really faint noise?
 

·
Registered
Joined
·
91 Posts
Discussion Starter · #4 ·
and it seemed alota mustang when the throw out bearing went bad it would make noise when the clutch was in. Mine only makes a very quiet noise when the clutch is fully out. Thanks for the help guys
 

·
Registered
Joined
·
129 Posts
I have the same problem with my 03 cobra. It frist was lil nosie and now its really bad the clutch pedal shacks crazy. Im doing the job this weekend. To even get to the throw out bearing u have to take the tranny out . im putting a new clutch too the tranny is already out. Gunna do it
now so i don;t have to do it down the road.
_______________________________________________
2003 cobra 487 rwhp
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top