Ford Mustang Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter #1
there are 2 pipe lines or something going to my catalic converters(sorry im a horriable speller)
but i dnt understand what these lines are?
its on a 94 mustang gt. if this helps at all.
one line on each converter.
 

·
Registered
Joined
·
607 Posts
its part of the emissions system. they thread into the back of the cylinder heads and are connected the air pump
 

·
Registered
Joined
·
78 Posts
Discussion Starter #3
****. cuz there tacked onto the cats. and i wanted to remove the cats. so anyway that i could remove them without sending codes and makeing my check engine light come on everytime?
 

·
Registered
Joined
·
200 Posts
anytime you remove the cats you bring the check engine on , Im not to sure on a 94 Ive only owned one of these cars. I cut cats off and put long tubed on it :bigthumbsup had to shave a piece of the clutch fork off and a bit of the a arm..:laugh: but i sounded badas check engine light did come on sometimes..
 

·
Registered
Joined
·
200 Posts
I have heard of a plug For a 5.0 motor that shuts the light off after exhaust work... may wanna check into it.
 

·
Registered
Joined
·
89 Posts
to get your check engine light to go of you will need to get a set of o2 sensor foolies summit has them for about 50$ bucks :bigthumbsup
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top