[robs91fox]

I have finally bought a nice pair of cylinder heads to begin my engine build over the winter. I picked up a set of Trick Flow 170 Track Heat heads.

Just looking for some opinions on what I intend to do here:

Intake: I have a GT40 now, but may have a lead on a Holley Systemax
Cam: TFS Stage 1
Rockers: Scorpion Race 1.6
Fuel System: 24 lb. Injectors, matching MAF, 190 LPH fuel pump

Plus everything I allready have in my signature below.

Any input on how well this will work or opinions on these parts would be appreciated.

Thanks

 

[306Notch]

Parts combo sounds pretty good to me for a stout street/strip motor.

What's the story on the bottom end? Rebuilt or re-ringing while you have it torn down?

And.. Subframes! Add them now if you haven't already. Big difference.

:bigthumbsup

 

[Smurf stang]

The Holley will really round out that combo. The cam is a nice mild cam and will compliment the car and it's street manners. It should be peppy.

 

[Bacon22]

You may want to add 1 3/4 inch long tubes. Not mandatory but it may get you a few horses. I have almost the exact same setup except a track heat manifold and it runs damn good. I wish I had long tubes and a systeMax though, oh and some traction would be nice lol

 

[Smurf stang]

You may want to add 1 3/4 inch long tubes. Not mandatory but it may get you a few horses. I have almost the exact same setup except a track heat manifold and it runs damn good. I wish I had long tubes and a systeMax though, oh and some traction would be nice lol

What is that? :laugh::laugh:

 

[Bacon22]

^Its a mythical creature, you know like a smurf!! :rockwoot: