the flywheel bolts and the pressure plate bolts yes, clutch no
Over Tightening Clutch
Is it possible to over tighten a clutch and break it?
- Status
- Not open for further replies.
1 - 7 of 7 Posts
what is the down fall of over tightening the flywheel bolts and pressure plate bolts?
they break off, and you have to take it all apart and have them taken out.... can get expensive!
buy new bolts from ford, and use a RELIABLE tq wrench and some BLUE thread locker and youll be ok
Thank you for the advice I will drop the tranny and double check that tomorrow!
if they are in
dont mess with them!
its jsut reccomended to change them when you change clutch, if they are good, dont bother them
hope you used loctite!
dont mess with them!
its jsut reccomended to change them when you change clutch, if they are good, dont bother them
hope you used loctite!
1 - 7 of 7 Posts
- Status
- Not open for further replies.
Ford Mustang Forum
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, builds, modifications, reviews, engine swaps, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Top Contributors this Month
View All
Cobrajet67
275 Replies
Forddenial
86 Replies
ONEZ ST
67 Replies
Recommended Communities
