PCM "Connector Views" missing from Service Manual - Upstream O2 pinouts please
I data logged my upstream O2 sensors today and the driver's side one is completely flatlined (Bank2 sensor1). It's a new sensor. I verified that the Violet-Grey wire is supplying power to the sensor connector when the ignition switch is on. I would now like to disconnect the appropriate PCM connector and verify continuity of the other 5 wires from the PCM to the O2 sensor connector. I found the wiring diagram so I know what colour the wires should be, but "Cell 150 Connector Views" is missing from the online manual here:
iihs.net
Does anyone have this diagram? Also, which of the three PCM connectors would the wires be on? I could probably un-wrap the harness a bit and look for those wires, but there will probably be wires for other things that are the same colour. Any help would be greatly appreciated.
I data logged my upstream O2 sensors today and the driver's side one is completely flatlined (Bank2 sensor1). It's a new sensor. I verified that the Violet-Grey wire is supplying power to the sensor connector when the ignition switch is on. I would now like to disconnect the appropriate PCM connector and verify continuity of the other 5 wires from the PCM to the O2 sensor connector. I found the wiring diagram so I know what colour the wires should be, but "Cell 150 Connector Views" is missing from the online manual here:
Ford Workshop Service & Repair Manuals - fordrepair.info - 2011 Mustang 2011 Mustang 003 - introduction
Ford Workshop Service and Repair Manuals, 2011 Mustang Wiring Diagrams 003 Introduction