Ford Mustang Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I've got pony emblems to put on my 2006 V6. The stock model comes with no emblems, so there are no positioning holes/marks. Can anyone give me the measurements from the belt line down to the bars and from the trailing fender edge to the bars?

Anyone who has the pony package would have the correct location.
 

·
Registered
Joined
·
4,388 Posts
did you get the bigger emblems like the 06 has or the smaller ones that have been out forever? this emblem is 2 3/4 tall. its 6" in from the door/fender edge and ite 7" up from the lower body line (top line) here is a pic with the small ponys. this had the GTs on it but the pony look better :) I used the factory fender holes..well one of them lined up..I had to cut the smaller pin off.
 

Attachments

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanks for the measurements. Actually, I've got the larger new ones. They are 4 3/8" tall, but your measurements may still work. I have to cut both pins since I have no factory alignment holes.
 

·
Registered
Joined
·
4,388 Posts
that is true bud...the numbers I gave you are to the center of my emblem...just do yours the same way...I like the bigger ponys..I may change mine :eek:)
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top