Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
I have a 90 gt and had to replace the pullie and power steering pump, no problem till I put the pressure hose back on. It seems to leak where it is suppose to swivle,and I had put new o-rings on the line?? And one else have this problem?
 

·
Registered
Joined
·
12 Posts
There shouldnt be any rubber o rings on those lines there should be a white plastic ring that goes around the threaded end of the pressure hose. The new pump probably had o-rings and those other plastic pieces which you would use. Anyhow hope that helps.
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #3 ·
Yup, I meant to say a white plastic ring, but I just went and got another one to try because I tore up the 1 that came with it. Where the pressure hose bends or shall I say the point where it swivles is where its leaks, hopefully this new plastic ring will work!
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top