Ford Mustang Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
145 Posts
Discussion Starter · #1 ·
well here we go again... putting an 04 gt motor in my 97 gt with my 97 harness, ecu, etc.. the aluminum crossover on my manifold of the 97 has two temp sensors while the 04 only has one. i can't find anyone with the right drill n tap its big like .75 and i cant just use my 97 aluminun cossover because the bolt hole patter is different.
 

·
Registered
Joined
·
145 Posts
Discussion Starter · #2 ·
the size actually is 3/8 by 18
 

·
Registered
Joined
·
7,401 Posts
A machine shop should be able to drill and tap it for pretty cheap.
 

·
Registered
Joined
·
849 Posts
I used to own a machine shop n we used to do things like that, just bring the 97 part or have good pics/diagrams so they know exactly what u want & need...
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top