Ford Mustang Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
when i go to tightin the bolt back up the nuts will only go about half way in then wont go any farther without force...THEN, DUM DUM DUM....were the bolts go into the plastic of the taillight it wants to breakoff...i've lubed the bolts up and the nuts trying to see if they'd go in any better and nothin...is the nuts that the GT lights and the ones used for the cobras the same?
 

·
Registered
Joined
·
186 Posts
it just seems when you start changing stuff thothing works the way you would like it to so you have to make it work. shorten the screws or just go buy some shorter ones
 

·
Registered
Joined
·
13 Posts
Discussion Starter #3
found out the prob..apparently the GT tails and cobra tail use diff thread pattern...i just changed the stud and all, Then it worked fine...damn i didn't understand what the whole fuss of the cobra tail were about...but they changed the whole ass end of my car...WOW what a diff!
 

·
Registered
Joined
·
46,010 Posts
The different taillights makes a HUGE difference. Getting rid of the GT cheesegraters cleans up the whole rear end, I did that and all I changed were the lenses.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top