Ford Mustang Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
174 Posts
Discussion Starter · #1 ·
I keep reading that i need to move pin 51 to pin 38 on the EEC-IV connector

and Pin 11 to pin 32 on the conector.

do i just disreguard the wires that were in pin 38 and 32 or do they go in place of where pin 51 and pin 38 used to be?

if they are not used can i cut the wires at pin 38 and 32 and use them to splice the MASS air wires into place instead of buying new pins?


any advice
 

·
Registered
Joined
·
956 Posts
there are connectors out there that plug into the existing plug and then you plug the mass air computer into the connector, the wire for the mass air sensor goes into the connector, i used this when converting to mass air, it may be a ford part, not sure
 

·
Registered
Joined
·
46,010 Posts
I did that too when I converted to mass air.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top