Ford Mustang Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter · #1 ·
Hi All,

What is the process used in removing and replacing cam bearings in a '65 200 cid 6 cyl engine? :headscratch: I've never removed them from a six before!

Harry
 

·
Super Moderator
Joined
·
40,152 Posts
use the proper cam bearing tool to do it....or just have the machineshop do it,does not cost much.
 

·
Registered
Joined
·
85 Posts
Discussion Starter · #4 ·
So that means drive them out with a puller and drive them in with a cam tool and a beater. OK. I've done that in a 289. The new cearing set I saw were split. I figured maybe it was easier on a six!

Thanks

Harry
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top