Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I am new to this so I hope I am doing this correctly. I have a 69 Mustang wiht a 302 engine. I am needing to replace the motor mount on the driver side. I have a Mustang book that helps with repair, but thre is nothing in there about it. I was wondering if anyone knew of a place i could go to get instructions to properly replace the mount? Thank you in advance.
 

·
Registered
Joined
·
9,198 Posts
Hello.Welcome.:)You need to support the engine from above with an engine hoist or a suitable substitute but after that it's just unbolt the old one and install the new one.I always replace both when I do one.I figure if one (normally the D/S) fails then the other is not far behind,so since I'm there anyway I might as well.But that's just me.Hope that helps.:)
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top