Rod Bearing Opinion Question
779
7
Hey everybody, I'm looking at replacing my rod bearings as they were starting to show some wear. I've found plenty of companies that make my bearings in .20 oversize (my crank was ground down), but the question is, Which company is the best?
Here are the 3 main companies I have found.
-Sealed Power
-Clevite 77
-Michigan
Which company do you guys think?
Here are the 3 main companies I have found.
-Sealed Power
-Clevite 77
-Michigan
Which company do you guys think?
- Status
1 - 1 of 1 Posts
Hey 66 or Cindy, not too familiar with rod bearings, but I just want to make sure when you buy the bearings, you have to get the bore size you have or however much you're going to bore your engine, correct? Would you have to replace the main bearing also? Not familiar with that either.
1 - 1 of 1 Posts
- Status
Join the discussion
