Ford Mustang Forum banner

Roof trim molding clips broken?

3212 Views 3 Replies 4 Participants Last post by  moonrakercat
Hey guys, I had my roof wrapped in vinyl today, and the clips that hold the roof molding/rails (drivers and passengers) broke loose.

It looks like they were just held by epoxy, and then the clips slide into the railing itself.

http://parts.autonationfordwhitebea...8-gas-engine/body-cat/exterior-trim-roof-scat

The above link is what I'm talking about.

Is this a common thing, or did the shop carelessly yank the molding off? I realize the clips are cheap, about $2.50 each, so should I go ahead and order more, and epoxy them back on in the same spots over the old epoxy residue, or should I just leave it? It's really not noticeable or anything, unless you slide the molding around with your hands.

The two rivets on the body of the car are still intact which hold the molding into place on both sides, so I'm fairly confident this thing won't fly off or go anywhere.

Thanks!
1 - 1 of 4 Posts
Like old school vinyl? Post a pic... I'd like to see what you are talking about.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top