Seat belts for a 1969 mach 1 mustang sportsroof

Bolts for the front driver and passenger seatbelts are technically not located on the floor boards/pan. They are located on the trans tunnel (1-each side) and on the inner rocker panel (1-each side) You will also find the third bolt location on the upper roof rail just behind the front seat (1-each side)

If someone replaced the seat pan with a replacement, it will be there as all the replacement panels alocate for the seatbelt bolt. If they used some plain sheet metal and not the acutal replacement pan, you have to get measurements and location from another car. The anchor plate (weld in) for the seatbelt is available

Mustang Seat Belt Bolt Anchor Plate 1965-1973 | CJ Pony Parts

i know for the shoulder harness on each side the bolts are there. So you are saying for the driver side the seat belt retractable will be on the left side of the driver on the inside side of the rocker pannel ? and for the passenger side it will be on the right side of the passemger on the right inside of the rocker pannel ? Also what about where the seat belt clips into next to the consel on each side ? Should ther be anchors there. I briefly looked at how to remove the front seats and

i saw square bolts in a tract with not much room to turn them to remove the front seats. any advise here ? Thanks for the help and input.
i am a novice but would like to do as much as I can to save $

1st Mach 1 said:

So you are saying for the driver side the seat belt retractable will be on the left side of the driver on the inside side of the rocker pannel ? and for the passenger side it will be on the right side of the passemger on the right inside of the rocker pannel ? Also what about where the seat belt clips into next to the consel on each side ? Should ther be anchors there. I briefly looked at how to remove the front seats and

i saw square bolts in a tract with not much room to turn them to remove the front seats. any advise here ? Thanks for the help and input.
i am a novice but would like to do as much as I can to save $

Click to expand...

Yes the retractor will bolt to the inner rocker panel left side below the door for the driver, rightside below the door for the passenger

The other bolts are an the trans tunnel (The part where the console fits)They will be on the "side of the trans tunnel relative to the seat.

To remove the seat, you do it from under the car. Look underneath and you will see for each seat either 4 large rubber plugs or 4 large holes where rubber plugs should be. Remove the plugs and the seat nuts for the seat tracks (4 nuts per seat). Remove the nuts and the seat will lift out