Ford Mustang Forum banner

Shelby drop on a 1966 Coupe

6514 Views 4 Replies 5 Participants Last post by  Proarms
I hope someone will be able to give me some good advice ..... I am upgrading my front brakes to discs and decided to install new upper and lower control arms and all new bushings up front. I received some good advice on doing a "shelby drop" on the upper control arms. The only thing that is stopping me is that I already purchased coil springs that will drop the stock height 1". My question is will the "shelby drop" drop my front end another 1"? I dropped the rear of the car 1" by installing mideye leaf springs and I dont want the front end to be too low for some decent size wheels. any help please!!!!!!!!!!!!!!!!!!!!
1 - 1 of 5 Posts
I did the Shelby drop with 1" lower 620 springs. I am still able to run 225/47/zr17 tiresup front. Speaking from experience, make sure that you replace your upper and lower ball joints while you are under there. If they are badly worn it can push your wheels forward and end up hitting the front fender.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.