Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
47 Posts
This is the first time I am attempting to change my stock plugs to new Denso Double Platinum. Removed #1 plug, vacuum some debris out & replaced it no problem. Removed #2, looked down the hole and there was a small piece of paper (looks like it was of those tags that are usually wrapped around wires. It was approximately 1/4" x 1/4" in size). I tried to vacuum it out, but unsuccessful. It fell down. Is this something to be concerned about?? My first guess is that it will burn off.
 

·
Registered
Joined
·
131 Posts
Is it paper or plastic? If it's paper, then it will probably burn off and leave minimal to no damage at all. Personally I wouldnt worry about it.

You'd be surprised at how much worse stuff you can find in the gas you pump into your car :sosad:
 

·
Registered
Joined
·
47 Posts
Discussion Starter #3
it is definately paper.
 

·
Registered
Joined
·
353 Posts
For future reference, before removing spark plugs.....always blow out the area with some compressed air.
 

·
Registered
Joined
·
47 Posts
Discussion Starter #5
Thanks for the advice. I will be sure to do that next time....
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top