Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
614 Posts
Discussion Starter · #1 ·
I have done a search on clutch installation but found nothing pertaining to SPEC clutches.

I installed the clutch a year ago and i am putting the motor in another car. Well when i took the pressure plate off the clutch fell out and i had to catch it before it hit the ground so i was not able to see how the clutch went in. I have found no markings to tell mne which side goes towards the flywheel.


The clutch has one flat side and the other side has a raised area, about 1/2" , that houses the dowel springs. I am assuming the flat side goes toward the flywheel. But I am not 100% sure. I cannot for remember at all and I dont want to install it backwards, so any help will be welcome.


THANKS

Drew
 

·
Registered
Joined
·
3,121 Posts
You are correct, the flad side of the disc goes towards the flywheel. :smoke:
 

·
Registered
Joined
·
614 Posts
Discussion Starter · #3 ·
Thanks, I had a brain fart and just couldnt remember at all. Thanks again


Drew
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top