Ford Mustang Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
653 Posts
Discussion Starter #1
Anyone else have problems with the spec stage I clutch lasting like four months?
 

·
Registered
Joined
·
10 Posts
I have the same clutch for a mach 1, did you replace all the bearings with the clutch, re-surface or replace flywheel, which cable are you using....factory or aftermarket?
 

·
Registered
Joined
·
87 Posts
i had the spec stage 2 installed, lasted like 3 months
went back to oem and haven't changed it since
if this one ever craps out on me (read: when i finally do too many burnouts) I'm putting in a centerforce df, i've heard way better things about them.
 

·
Registered
Joined
·
653 Posts
Discussion Starter #4
I replaced everything clutch wise, pilot bearing, new slave, and a spec flywheel. I can't remember all the part manufacturers off the top of my head. But I'm not impressed. I was looking for something to outlast stock, but ended up with worse. I'm considering a centerforce dual friction in the near future, because this quality is ridiculous. Every time I put it in reverse I smell clutch. Either it wasn't installed right (mechanic shop) or this clutch is not for the spirited driver at all.
 
1 - 4 of 4 Posts
Top