Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter #1
I was thinking of painting my Exterior Door Window Belt Molding Trim on my GT because its has spots of silver where the black cliped off. I noticed on a the shop horsepower tv about 6months ago they did to the project camaro. its about 20 dollars in supplies. I just dont know the exact supplies they used. Thanks for the help guys
 

·
Registered
Joined
·
382 Posts

·
Registered
Joined
·
1,241 Posts
i painted mine with SEM trim paint. its the best rattle can paint ive used.

all you need to do is sand it with fine grit sandpaper, prob 320 grit, then wipe it down with acetone, and then paint.

i think the SEM paint is about 10$ a can and a gallon of acetone is about the same.
 

·
Registered
Joined
·
46,020 Posts
You can prep and paint them yourself, just get some filler primer if they're pitted rather than smooth. If they're smooth, then just lightly sand, clean, and then paint. If they're pitted, prime/sand/prime/sand until they're smooth, then clean and paint. You can then decide whether flat, satin, or gloss black you want.
 

·
Registered
Joined
·
41 Posts
Discussion Starter #5
thanks...i might just buy new ones since they are about 35 a piece. How hard would it be to install? how do they come off
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top