Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
Anyone know of a T top cut out in a mustang? I was thinking of how much of a project it would be to just cut out two roof holes then mount those cutouts back on, so I wouldnt have to deal with getting custom glass to match the contour of the roof. Any thoughts? Absolutely crazy? We have plenty of access to all tools and a good amount of experience with body work.
 

·
Registered
Joined
·
28 Posts
Discussion Starter #2
I was thinking of cutting a bigger hole in the top layer of the roof, then a slightly smaller hole through the bottom layer, then making a frame that the two panels sit on to be flush with the roof, and they would seal around the frame as well. Latches should be not too difficult to design.

Im mainly wondering if the holes in that particular location would compromise the strength of the roof? Probably not right?
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top